11/25/2023 0 Comments Corsair dcommander pro![]() ![]() Please only do after first turning off the computer and completely unplugged it for the mains. A more prudent method would be to apply Isopropyl Alcohol (IPA) on the joints (careful, it is very flammable but evaporates quickly) on the connectors you suspect are experiencing problems (do both ends of the cable). The simple act of unplugging/re-plugging usually "scratches" off some of the oxidation and provides a better contact. I've had the odd time (pre-Corsair equipment days) where I've had to unplug/re-plug a cable that had exhibited oxidation to get them to work. ![]() I live near the beach and as such, am subjected to salt air. an AX/HX series set when they should have bought a RX series kit) but that's usually more dramatic as the pin-out configuration on the PSU side may differ between the PSU series - see Corsair PSU cable compatibility for further details. ![]() The only other issue I've heard of is when people purchase the wrong kit (e.g. CaleMod on the whole are well made but there's a chance you have a cable with a less than perfect connection - things happen. My son has CableMod Pro (ModMesh) extensions on his HX1200i (and uses a couple of CableMod SATA extension cables) again without issues. I use a full CableMod (ModFlex) kit paired with an AX1200i and have 2 x CoPro's running off my system without any issues. and to reply to yout question i was using the sata cable by cablemod and not the extension. what do you recommend me to with the cablemod cables? should i throw them out and use the one that i got with the psu safer? and what have when u have a dry joint? this ssta cable the one that commander pro didnt run has many components connected to it? do u think i will fry them if i keep using it?, thank u again. ![]() I wanna thank you so much for replying to.me and the fact youre an electronic engineer. I suspect you'd see the CoPro in ICUE with just the USB cable as the SATA connection is likely only used to supply the +12V required by the fans. Your description of "can see it in ICUE but the fans are not spinning" and the fact that replacing the SATA cable fixed the problem leads me to the dry joint issue. When I select one, and hit Detect on the PWM Fan entry, it returns the following: So, in the Dynamix Fan Auto Control plugin lists the fans attached to the CCP. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |